IMG_5805.jpg

Hardware care

Our hardware may oxidise slightly over time depending on location and use. To help remove oxides from brass gently rub the surface with a green Scotchbrite scourer in a circular motion (this is how we finish all our work with a brushed finish). Gently wash in warm water, wipe off any residue and make sure the piece is completely dry before applying a thin coating of bees wax to help slow down future oxidisation and further protect the surface.  

U handle large.jpg

Hardware installation

Brass Curve & Cloud hooks

Wood - Drill a 2.5mm ø pilot hole. Install using the supplied brass screw.

Masonry - Install using a 5mm ø white masonry wall plug to the manufacturers instructions. Install using the supplied brass screw.

Plasterboard - Install using a Ramset spring toggle (50mm long with 1/8 inch ø thread) to the manufacturers instructions.

Brass Cup & Cloud pulls, U handle

Install pulls onto draws & doors by drilling a 2.5mm ø pilot hole and install using the supplied brass screw.

Steel Segment pulls

Install pulls onto draws & doors by drilling 5.5mm dia screw holes. The supplied screw suits a 15 to 20mm thick draw front or door and is installed with a 3mm allen key. Please let us know if you have a draw / cupboard front that's outside these dimensions and we can supply a suitable length screw.